Here Are The Solutions. Please Observe Carefully.
N70, N72 Not Charging Problem 1
N70, N72 Not Charging Problem 2
N70, N72 Not Charging Problem 3
N70, N72 Not Charging Problem 4
N70, N72 Not Charging Problem 5
N70, N72 Not Charging Problem 6
Showing posts with label NOKIA REPAIER SOFTWARES. Show all posts
Showing posts with label NOKIA REPAIER SOFTWARES. Show all posts
Tuesday, July 19, 2011
Thursday, January 27, 2011
3100b rh50 to 3100
3100b rh50 to 3100 rh19
flash it with rh19
write 3100 special pm file for speaker
ui settings.
flash it with rh19
write 3100 special pm file for speaker
ui settings.
3600 to 3650
3600 to 3650change filters
flash the phone with 3650 flash files v3.16 ,write good pm and ui settings.
Click this bar to view the full image.8390 to 8310
8390 to 8310
1. Jumper resistor is a resistor (not actually a resistor) with 0 ohm value, usually colored green with 0 markings.
Wire can also be use instead, but must not be very thin and should be as short as possible. Thin and long wire will introduce high inductive reactance and will result to weak received signal.
2. T500 can be taken from 3310 unit. It is located just above HAGAR, refer to your service manual to easily locate it. Also take note to its pin orientation during installation.
Bypassing Z551 with wires is not recommended,this will weaken the receiver sensitivity due to incorrect signal phase relationship.
3. Give special attention when installing VCO, improper positioning will result to no network activity
This image has been resized. Click this bar to view the full image. The original image is sized 730x464.
1. Jumper resistor is a resistor (not actually a resistor) with 0 ohm value, usually colored green with 0 markings.
Wire can also be use instead, but must not be very thin and should be as short as possible. Thin and long wire will introduce high inductive reactance and will result to weak received signal.
2. T500 can be taken from 3310 unit. It is located just above HAGAR, refer to your service manual to easily locate it. Also take note to its pin orientation during installation.
Bypassing Z551 with wires is not recommended,this will weaken the receiver sensitivity due to incorrect signal phase relationship.
3. Give special attention when installing VCO, improper positioning will result to no network activity
This image has been resized. Click this bar to view the full image. The original image is sized 730x464.
nokia 3390b to 3310 converting solution.
here is nokia 3390b to 3310 converting solution.
full flash with 3310 firmware and do hardware like in picture.
This image has been resized. Click this bar to view the full image. The original image is sized 953x438.
full flash with 3310 firmware and do hardware like in picture.
This image has been resized. Click this bar to view the full image. The original image is sized 953x438.NOKIA 1100b-1100
1100b-1100
Procedure:
1. erase flash
2. flash with 1100(rh18)
3. change filters
4. write pm
5. unlock
Procedure:
1. erase flash
2. flash with 1100(rh18)
3. change filters
4. write pm
5. unlock
Subscribe to:
Posts (Atom)
Posts
